Meta System HPB TOP PLIP

Need help?

Do you have a question about the Meta System HPB TOP PLIP and is the answer not in the manual?

Summary

PLIP Signal Selection

Vehicle Specific PLIP Commands

Lists and describes arming/disarming commands for various vehicle groups.

Product Setup Procedures

Product Setup Overview and Manual Configuration

Guidance on selecting the correct CAN, using the programmer, and manual setup procedures.

Quick Link-up of Electronic Keys

Procedure for linking electronic keys to the product during initial fitting.

Key and Override Code Management

Rapid Storing of Electronic Keys

Procedure for inserting and memorizing up to four electronic keys for the alarm system.

Override Code Customisation

Steps to modify the product's override code, including key memorisation procedures.

Operating Mode and Blinker Control

Operating Mode Customisation

Table showing operating modes and how to change factory settings via switch and indicators.

Blinker Control Selection During Alarm

How to select Blinker control for alarm activation, including power and vehicle buttons.

Original Remote Control Integration

Connection to Original Remote Control

Instructions for connecting the alarm to the vehicle's original central locking system.

Static and PSA Command Details

Breakdown of Static and PSA arming/disarming commands, including polarity and type selection.

Advanced Procedures and Safety Checks

Inhibition of Ultrasonics

Procedure to voluntarily exclude ultrasonic protection from the alarm system.

Final System Check and Override Restoration

Steps to verify correct functionality and restore override safety after installation.