ENGLISH
15
ENG
failure, for reasons of safety the still switched-on
machine will not start. To continue operation
switch the machine off, then on again.
Slow flashing - carbon brushes worn
The carbon brushes are almost completely worn. If
the brushes are completely worn, the machine
switches off automatically. Have the brushes
replaced by an authorized service centre.
f
Use only genuine Metabo accessories.
If you need accessories, check with your dealer.
For the dealer to select the correct accessory, he
needs to know the exact model designation of
your power tool.
See page 4.
A Tools with SDS-plus shank
B Twist drills for metal and wood
C TCT core cutter
D Dust extraction kit
E Special grease (for lubricating the tool shanks)
For complete range of accessories, see
www.metabo.com or the main catalogue.
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please attach a description of the fault to the
power tool.
Metabo's packaging can be 100% recycled.
Worn out power tools and accessories contain
considerable amounts of valuable raw and plastic
materials, which can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline
2002/96/EC on used electronic and electric
equipment and its implementation in national
legal systems, used power tools must be collected
separately and handed in for environmentally
compatible recycling.
Explanatory notes on the information on page 2.
Changes due to technological progress reserved.
P
1
= rated input
P
2
= rated output
n
1
= no-load speed
n
2
= load speed
ø max = max. solid drill diameter
s max = max. impact rate
W = single impact strength
m=weight
D = spindle collar diameter
b = drill chuck chucking capacity
Vibration total value (vector sum of three
directions) determined in accordance with
EN 60745:
a
h, HD
= Vibration emission value
(hammer drilling into concrete)
a
h, Cheq
= Vibration emission value
(chiselling)
K
h,HD/Cheq
= Unsafe (vibration)
The vibration emission level given in this informa-
tion sheet has been measured in accordance with
a standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with different
accessories or poorly maintained, the vibration
emission may differ. This may significantly
increase the exposure level over the total working
period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not
actually doing the job. This may significantly
reduce the exposure level over the total working
period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
Typical A-effective perceived sound levels:
L
pA
= Sound pressure level
L
WA
= Acoustic power level
K
pA
, K
WA
= Unsafe (noise level)
During operation, the acoustic level may
exceed 85 dB(A).
Wear hearing protection!
Measured values established according to
EN 60745.
The stated technical specifications are subject to
tolerances (as specified in the respective current
standards).
12 Accessories
13 Repairs
14 Environmetal Protection
15 Technical Specifications
17024961_0708 BH ohne GummP.book Seite 15 Donnerstag, 3. Juli 2008 3:21 15
To Next Page
Loading...
Need help?
General
