Metabo FMS 200 Intec Operating Instructions

10
ENGLISH
ENG
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Sanding plate (as replacement)
B Dust collection box with fluted filter for
multiple cleaning (as replacement)
C Fluted filter (as replacement)
D Perforated adhesive sanding discs for all
types of wood, 2-piece, 100 x 150 mm
E Perforated adhesive sanding discs for paint,
lacquer, spattle, 2-piece, 100 x 150 mm
F Dust extraction connection
G Metabo universal vacuum cleaner
For complete range of accessories, see
www.metabo.com or the main catalogue.
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.
Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately
and handed in for environmentally compatible
recycling.
Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
D = Dimensions of sanding plate
P
1
= Nominal power input
P
2
=Power output
s
0
= orbital frequency at no load
s
1
= orbital frequency at nominal load
S = Oscillating circuit diameter
Intec = Dust collection box
m = Weight without mains cable
a
hw
= Typical estimated acceleration in the
hand/arm area
Typical A-effective perceived sound levels:
L
pA
= Sound pressure level
K
pA
= Unsafe
During operation the noise level can exceed
85 dB(A).
Wear ear protectors!
Measured values determined in conformity with
EN 60745.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
11 Accessories
12 Repairs
13 Environmental Protection
14 Technical Specifications
17026742_0606 FMS 200 Intec.book Seite 10 Donnerstag, 1. Juni 2006 11:41 11

Metabo FMS 200 Intec Specifications

General

Brand	Metabo
Model	FMS 200 Intec
Category	Grinder
Language	English