Metabo Spindle Moulder TF 100 M User Manual

Operating Instructions Spindle Moulder
Instructions de service Fraiseuse de table
Bruksanvisning Bordfres
Käyttöohje pöytäjyrsinkone
Handledning bänkfräsmaskin
TF 100 M
ENG
F
115 160 0294 / ENG/F/NO/FIN/SV / 3605 - 4.0
FIN
SV
NO
Attention! Carefully read through these instructions prior to installation and commissioning.
Attention! Prière de lire attentivement la présente notice avant l'installation et la mise en service.
Se opp! Vær så vennlig å først gjennomlese nøyaktig denne veiledningen før installasjonen og idriftsettelsen.
Huomio! Lue tämä ohje huolellisesti läpi ennen asennusta ja käyttöönottoa.
Observera! Var god och läs noga igenom denna handledning före installering och idrifttagande.
SV
ENG
FIN
NO
F

Metabo Spindle Moulder TF 100 M Specifications

General

Brand	Metabo
Model	Spindle Moulder TF 100 M
Category	Power Tool
Language	English

Summary

Specifications

Noise Emission

Details noise emission levels for the spindle moulder according to DIN 45 635.

User Responsibility

Standard Accessories

Optional Accessories

Final Assembly

Installation

Commissioning

1-Phase Power Supply

Guidelines for connecting the machine to a single-phase power supply, including voltage and fuse requirements.

3-Phase Power Supply

Requirements for connecting the machine to a three-phase power supply, including plug type and fuse ratings.

Direction Of Rotation

How to check and change the spindle's direction of rotation for safety.

Switch

Explanation of how to start and stop the spindle moulder using the push-buttons.

Overload Protection

Describes the motor's overload protection and how to reset it after tripping.

No-Voltage Release

Explains the no-voltage release feature preventing automatic restart after power failure.

Dust Collection

Specifies requirements for dust collection, including minimum air flow rate and outlet size.

Dust Collector Automatic Start

Details the electrical setup for automatic dust collector activation with the machine.

Safety Information

Workpiece Dimensions

Scope Of Application

Tool Dimensions/Cutting Speeds

Jigs And Push Blocks

Controls

Definitions

Defines key components of the spindle moulder, illustrated with a diagram.

Mounting A Tool

Step-by-step guide on how to safely mount and secure cutting tools onto the spindle.

Spindle Speed Setting/Changing

Instructions on how to adjust or change the spindle's rotational speed by altering the belt drive.

Tool Height Setting

Procedures for adjusting the cutting tool's height relative to the table surface.

Fence And Fence Plate Setting

Guidance on adjusting the fence and fence plates for proper workpiece alignment.

Cutter Guard Setting

Instructions for setting the cutter guard, holddown shoe, and pressure for safe operation.

Operation

Tools

Specifies the types of tools approved for use with the spindle moulder, emphasizing safety features.

Stock Prechecking

Advice on preparing workpieces, including checking for warping and proper fit on the table.

Moulding Strips

Procedures for moulding narrow strips, including tool setup and feeding techniques.

Moulding Boards

Guidance on moulding wider boards, including cutter guard adjustment and feeding methods.

Making Tenons

Instructions for cutting tenons and grooves using the optional sliding carriage for secure guidance.

Set-In Work

Steps for performing set-in work, requiring table extensions and proper backstop adjustment.

Care And Maintenance