ENGLISH en
9
Attach parallel guide (
Fig. G-II)
- Slide the rod on the circular-cutting and parallel
guide sideways into the footplate (centre point (c)
faces upwards).
- Set the dimension (e)
- Tighten screw (b).
For a complete range of accessories, see
www.metabo.com or the catalogue.
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If you have Metabo electrical tools that require
repairs, please contact your Metabo service centre.
For addresses see www.metabo.com.
You can download spare parts lists from
www.metabo.com.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Fig. H.
Changes due to technological progress
reserved.
T
1
=Maximum material thickness in wood
T
2
=Maximum material thickness in non-
ferrous metals
T
3
=Maximum material thickness in sheet
steel
n
0
=Stroke rate at idle speed
P
1
=Nominal power input
P
2
=Power output
I
120 V
=Current at 120 V
m =Weight without mains cable
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Energy-rich, high-frequency interference can cause
fluctuations in speed and eventually standstill.
However, the fluctuations disappear as soon as the
interference fades away.
Wear ear protectors!
11. Repairs
12. Environmental Protection
13. Technical Specifications
To Next Page
Loading...
Need help?
General
