Mixer Body
Assembly
Nozzles
Refer to next
page for correct
nozzle selection.
Faceplate
O-ring
Grub Screw
Hex Key
Screws
Faceplate Cover
Handle
IMPORTANT: Please read all of the instructions before installation.
General:
• Methven recommends this product is installed by a licensed plumber
in compliance with all relevant regional regulations.
• All pipe work must be thoroughly flushed prior to the installation of
the mixer.
• In-line filters must be fitted on both hot and cold supplies to prevent
foreign particles damaging the ceramic cartridge.
• After installation all connections must be checked for leaks.
• All outlets used primarily for personal hygiene shall deliver water at a
safe temperature as per regional regulations.
• This mixer is not recommended for use in uncontrolled heating
systems such as wet-backs or solar heating units unless a suitable
tempering valve is fitted.
• It is the responsibility of the installer to ensure a waterproof seal is
achieved between the product and mounting surface. If in doubt
about the quality of the seal, remove the product and reinstall using
silicone to ensure a seal is achieved.
To Next Page
Loading...
