METHVEN KIRI User Manual

Issue D433176
KIRI SHOWER MIXER WITH DIVERTOR
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min: 150kPa, Max 500kPa
Recommended installation of a pressure limiting valve if supply pressure exceeds 500kPa
Operating Temperature:
Recommended 50°C at the mixer
Hot: Max 80°C
Cold: Min 5°C
NB: New Zealand Building Code Clause G12 - Water Supplies specifies all outlets used primarily for personal
hygiene shall deliver water at a safe temperature.
Inlet Connections: All ½” BSP
Methven warrants this product against manufacturing defects and that it is suitable for use
under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
Ceramic cartridge adjustment
Do not remove the ceramic cartridge from the
body assembly while carrying out the following
adjustments. Note, the cartridge is factory set
for maximum temperature.
Remove half-dome (if attached)
Flow limiting adjustment
Mix temperature limiting adjustment
+
-
+
-

METHVEN KIRI Specifications

General

Brand	METHVEN
Model	KIRI
Category	Plumbing Product
Language	English

Summary

Ceramic Cartridge Adjustment

Flow Limiting Adjustment

Adjusts the flow rate of water through the mixer.

Mix Temperature Limiting Adjustment

Limits the maximum temperature of the mixed water output.

Technical Specifications

Operating Pressure

Specifies the minimum and maximum water pressure for operation.

Operating Temperature

Recommended and maximum hot water temperatures for safe use.

Inlet Connections

Details the type and size of the water supply connections.

Installation Steps Overview

Component Identification

Identifies key components of the shower mixer assembly.

Mounting and Lining Distance

Specifies the correct distance from the mounting stud to the front of the lining.

Tool Usage

Indicates the specific tool required for certain adjustments.