What to do if my Metkon FORCIPOL 300-1V Grinder machine does not start?
If your Metkon Grinder doesn't start, first ensure the main switch is turned ON. If it still doesn't start, check the fuses at the back and replace any that are blown.
Why is the cooling water not flowing in my Metkon FORCIPOL 300-1V Grinder?
If the cooling water isn't flowing in your Metkon Grinder, check if the water button is closed and turn it ON. Also, verify that the valve on the water tap is open, and if not, turn the valve ON.
How to fix a Metkon FORCIPOL 300-1V when water is not draining away?
If water isn't draining from your Metkon Grinder, it could be due to several reasons: 1. The drain hose might be clogged. Clean the drain gap and hose. 2. The drain hose could be squeezed. Check the outlet hose and straighten it. 3. The drain hose might not have an even slope. Adjust the hose to ensure an even slope.
Why is there vibration on the grinding wheel of my Metkon FORCIPOL 300-1V Grinder?
Vibration on the grinding wheel of your Metkon Grinder may be caused by dirt on the faceplate or under the grinding wheel. Clean the contact surface between the grinding wheel and the face plate.
How to reduce noise when starting my Metkon FORCIPOL 300-1V Grinder?
If you hear noise when your Metkon Grinder starts, it might be because the belt is not tight enough. The belt must be tightened.
What to do if the power lamp is on but the display doesn't exist on my Metkon FORCIPOL 300-1V Grinder?
If the power lamp is on but the display doesn't exist on your Metkon Grinder, check the data cable between the frequency converter and the display board for any connection problems.
Essential safety guidelines for operating and maintaining the FORCIPOL system.
Procedure for unpacking and verifying all components received with the FORCIPOL unit.
Instructions for placing the FORCIPOL unit and making necessary water and power connections.
Guidance on connecting the FORCIPOL to mains power, including voltage and fuse ratings.
Details on recommended cooling water flow rate, hose diameters, and connection points.
Explanation of the function of each button on the FORCIPOL control panel.
Instructions for operating the FORCIPOL unit, including ON/OFF and water controls.
Common faults, their causes, and recommended actions for the FORCIPOL unit.
General| Model | FORCIPOL 300-1V |
|---|---|
| Category | Grinder |
| Wheel Diameter | 300 mm |
| Platen Speed | 50-600 rpm |
| Frequency | 50/60 Hz |
To Next Page
