METOFIX VM128 - Page 11

EN
11
REFERENCE TABLE
TYPES OF MATERIAL (1-9)
MAT Soort Omschrijving
1 Relative scale
Basic display of relative humidity
2
Anhydrite Screed
(Wt%)
For measurements of anhydrite screeds. The
measured value corresponds approximately to
a CM measuring instrument
3
Anhydrite Screed
(Wt/CM%)
For measurements of anhydrite screeds. The
measured value corresponds approximately to
the Carbid method (CM)
4
Cement Screed
(Wt%)
For measurements of cement screeds. The
amount of moisture is shown as a percentage
of the weight
5
Cement Screed
(CM%)
For measurements of cement screeds. The
measured value corresponds approximately to
the Carbid method (CM)
6
Concrete
(Wt%)
For measurements of concrete. The amount
of moisture is shown as a percentage of
the weight
7
Gypsum Screed
(Wt/CM%)
For measurements of stucco. The amount
of moisture is shown as a percentage of
the weight
8
Hardwood / Oak
(Wt%)
For measuring hard wood with a density of 0.6
to 0.9 (103 kg / m3) such as oak. The value is
in percentage.
9
Softwood /
Spruce
(Wt%)
For measuring soft wood with a density of 0.4
to 0.55 (103 kg / m3) such as  ring. The value
is in percentage.
Attention: These measurements correspond
approximately to a CM measurement,
but does not replace these!
Comparising table (rel. scale mat.1)
Dry Normal Wet
Gypsum Screed
Cement based
materials CM-%
Cement based
materials WT%
CM-% = percentile based on calcium-carbid methode
M-% = Mass-%
This instrument is calibrated by performing measurements on
identical dry materials. These values are used as reference values
for the measurements you perform.