2
I. INTRODUCTION
A. IDENTIFYING YOUR CABINET
Your cabinet assembly has been shipped in
two cartons. The first carton contains the
cabinet with module. The other carton contains
the slide racks.
There are several component numbers which
you may want to record for future reference:
the cabinet model number, the module model
number along with the module serial number
and the slide rack model number. Refer to the
photo at right to locate these numbers. The
slide rack model number is located on the
label affixed to the ends of the rack carton. It is
recommended that all numbers be recorded in
an appropriate place, such as at the bottom of
this page. AIso, please record the cabinet
model number and module serial number on
the Warranty Card found at the back of this
manual. Be sure to complete the remainder of
the Warranty Card and return it to Metro within
fifteen (15) days of delivery of the cabinet.
Once you have located and recorded these
numbers, refer to the sample numbers given
below to identify the components of your C175
series cabinet.
NOTE: Please read this manual thoroughly before using your
cabinet. If you should have questions, please contact
Metro customer service department.
Your C175 series cabinet has a full-view
polycarbonate door which allows unobstructed
viewing of the cabinet contents. To prevent shipping
damage to the clear panel, the protective paper
masking the panel, has been left on. Before putting
your cabinet into service, be sure to remove the
masking. Should the masking be difficult to remove,
refer to the Specific Cleaning Instructions section of
this manual for demasking instructions.
LOCATION OF
MODEL NUMBER
▼
LOCATION OF
MODULE MODEL
NUMBER AND
SERIAL NUMBER
▼
SAMPLE OF CABINET LABELING
C175-HM2000
Indicates Module
HM2000=Holding
CM2000=Combo
PM2X675=Proofer
Cabinet Series
(Full Height Cabinet)
C175T-HM2000
Indicates Module
HM2000=Holding
CM2000=Combo
PM2X675=Proofer
Cabinet Series
(
3
/4 Height Cabinet)
C4SC-T (
3
/4 Height Cabinet)
Indicates Slide Racks
C4SC-T = Wire 3" Spacing
C8SN-T = Aluminum Fixed on 1
1
/2" Spacing
CVSN-T = Aluminum Adjustable
SAMPLE OF SLIDE RACK
CARTON LABELING
C4SC (Full Height Cabinet)
Indicates Slide Racks
C4SC= Wire 3" Spacing
C8SN= Aluminum Fixed on 1
1
/2" Spacing
CVSN= Aluminum Adjustable
To Next Page
Loading...
Need help?
General
