Metro DataVac DATA-VAC/2 User Manual

INSTRUCTIONS FOR THE USE AND CARE OF YOUR
: METRO DATA-VAC/2 AND METRO DATA-VAC/3
ATTENTION
DATA-VAC/2, MODEL MDV-2 AND DATA-VAC/3, MODEL MDV-3 HAS TONER PICK-UP
CAPABILITIES WHEN USED WITH TONER FILTERS AND TONER BAGS. CAUTION:
DO NOT USE DATA-VAC/2 OR DATA-VAC/3 FOR TONER PICK-UP WITHOUT SPECIAL
FILTRATION PARTS.
1. Start appliance by pushing the toggle switch either left or
right. The two speed switch controls the power level of the
DATA VAC/3. The off position is in the middle.
2. HOSE: When use of hose is desired, connect to suction end
of the DATA-VAC for cleaning purposes, to exhaust end for
blowing purposes.
3. EXTENSION WANDS: Reach those inaccessible spots. Eliminate
bending to clean low areas and under furniture...stretching
to reach high areas.
4. "PIK-ALL" NOZZLE: Cleans desks, chairs, filters, upholstery,
furniture. Can also be used as “air defuser" by placing on
exhaust end.
5.
CREVICE
TOOL:
Cleans
those
hard-to-reach
tight
spots.
Can
be
used
for
vacuuming
and blowing
purposes.
6.
POWERIZER/AIR
MAXIMIZER:
This
tapered
accessory
concentrates
and
maximizes
air
flow
for
both
vacuuming
and
blowing
purposes.
7.
DUST
BRUSH:
The
perfect
tool
to
clean
keyboards,
terminals,
printers,
cables
and other
peripherals.
AIR .PINPOINTER
AIR PINPOINTER: Narrows air flow down to mere millimeters for
blowing into sensitive, hard-to-reach areas - between keys, printer,
disc
drive,
etc.
Exclusive
CFM
power
control
on
hose
reduces
air
flow for both vacuuming and blowing.
CAUTION
1. If your DATA-VAC has suction but does not clean when hose
is
attached,
remove
hose
from
suction
end
and
place
onto
blower
end.
Blow
out
the
hose...sometimes
it
might
be
clogged.
Empty cloth after each cleaning.
Foam filter should be replaced three times a year,
FORM #146-MDV-III

Metro DataVac DATA-VAC/2 Specifications

General

Brand	Metro DataVac
Model	DATA-VAC/2
Category	Vacuum Cleaner
Language	English