Metro Mobility M1 Plus - Page 35

34
Warnings
⚫ This device or system should be kept away from other equipments. If
they must be put together, pls check whether the device or system can
run normally.
⚫ You should consider the original manufacturer of the device or system
as the sole supplier. Failure to do so may cause EMC increase and or
decrease anti-EMC ability.
Attachments：
Guidance and manufacturer’s Declaration–electromagnetic
emission
（SW-1000S Plus scooter）is intended for use in the electromagnetic
environment specified below. The customer or the user of the
（SW-1000S Plus scooter） should assure that it is used in
such an environment.
Emission Test
Compliance
Electromagnetic
environment–guidance
RF Emission
CISPR 11
Group 1
(SW-1000S Plus scooter)
use RF energy only for its
internal function. Therefore,
it’s RF emissions are very
low and are not likely to
cause any interference in
nearby electronic
equipment.
RF Emission
CISPR 11
Class B
(SW-1000S Plus scooter) is
suitable for use in all
establishments, including
domestic establishment and
those directly connected to
the public low-voltage power
Harmonic Emissions
IEC 61000S-3-2
Class A