When the installation is complete, you will find a program link “EZMag3D
<version>” on your desktop. You will find the same program link in the folder
Metrolab of the Start Menu, alongside a link “EZMag3D <version> Manual” to the
online help. As usual, you can also access these items via a search.
2-2-2 Software Removal
• In the Explorer, delete the EZMag3D parameter folder shown in the
Settings screen. By default, it is in your AppData folder.
• Open the Apps & Features settings panel.
• Uninstall Metrolab EZMag3D.
• Uninstall UsbK Development Kit.
2-3 MACINTOSH SOFTWARE INSTALLATION AND REMOVAL
2-3-1 Software Installation
• Run the EZMag3D installer, Metrolab-EZMag3D-InstallerMacOs, following
the on-screen instructions.
Note that the default installation location is in your personal Applications folder,
not the system-wide Applications folder.
When the installation is complete, you will find the program EZMag3D in the folder
you specified during installation. In the same folder, you will also find a link
“EZMag3D Manual” to the online help. As usual, you can launch EZMag3D by
double-clicking its icon; you can also create an alias on the Dock or Desktop, or
you can launch it from a Spotlight search.
2-3-2 Software Removal
• In the Finder, delete the EZMag3D parameter folder shown in the Settings
screen. By default, this is ~/Library/Application Support/EZMag3D; since
your Library folder is usually hidden, you have to select the Finder's Go >
Go to Folder... menu item, and then enter ~/Library/Application
Support/EZMag3D.
• Open the program folder that you specified during installation
(~/Applications/EZMag3D <version> by default) and run the program
EZMag3D Uninstaller.
To Next Page
Loading...