All-Engineering BV
https://metrumacoustics.com
info@metrumacoustics.com
Be wary of any device that outputs more than the Industry Standard 2V output. This will
falsify comparison … so begs the question – why do some manufacturers do this ?
Only one answer!
Headphone volume control is designed to power lower impedance models down to 16 Ohms.
4 Volts is available on loads between 16 and infinity … so power is constant regardless of the
load.
When Phones are connected, volume control becomes active and when disconnected, the
Analogue outputs become active with volume control muted.
With the Analogue output circuits in play, all power is diverted to DAC performance.
note:
The AMETHYST will reach its maximum performance after a three to four
weeks usage.
To Next Page
Loading...
