Metso Outotec Lokotrack ST4.8

Questions and Answers

S
smithcodyAug 13, 2025
How to troubleshoot a system display that does not start on Metso Outotec Lokotrack ST4.8 Industrial Equipment?
- B
  Brad SimmonsAug 13, 2025
  If the system display of your Metso Outotec Industrial Equipment does not start, several issues might be at play. The battery could be empty, the main switch might be in the OFF position, or the battery clamps might not be properly attached. Ensure the main switch is ON and that the battery clamps are securely attached. You can also try charging the battery of the Lokotrack unit, jump starting the engine with another machine or vehicle, or using a jump starter.
S
Steven WhiteAug 17, 2025
What does it mean when the system display shows an emergency stop alarm on Metso Outotec Lokotrack ST4.8 Industrial Equipment?
- M
  Mario Collins MDAug 17, 2025
  If the system display of your Metso Outotec Industrial Equipment shows an emergency stop alarm, it means that one or more emergency stop buttons have been pressed down. Handle the emergency stop alarm.
N
Nicole NguyenAug 21, 2025
What does the ‘A17: Remote stop active’ alarm mean on Metso Outotec Lokotrack ST4.8 Industrial Equipment?
- G
  gruizAug 21, 2025
  If the system display of your Metso Outotec Industrial Equipment shows ‘A17: Remote stop active’ alarm, it indicates that the remote stop button is pressed down. Handle the 'A17: Remote stop active' alarm.
E
Emily SolisAug 25, 2025
Why is track drive not working if manual controls are active in Metso Outotec Lokotrack ST4.8 Industrial Equipment?
- S
  sphamAug 25, 2025
  If the track drive is not working on your Metso Outotec Industrial Equipment, it could be due to active manual controls. Check if manual controls are active.
B
Brenda BuchananAug 28, 2025
What to do if engine start failed because of low hydraulic oil level in Metso Outotec Lokotrack ST4.8 Industrial Equipment?
- S
  Stacy CollinsAug 28, 2025
  If the engine of your Metso Outotec Industrial Equipment fails to start and the hydraulic oil level is too low, check the hydraulic oil level and look for possible leaks.
J
James CohenAug 31, 2025
What to do if engine start failed because hydraulic shut-off valve is closed in Metso Outotec Industrial Equipment?
- C
  Carolyn JohnsonSep 1, 2025
  If the engine of your Metso Outotec Industrial Equipment fails to start because the hydraulic shut-off valve is closed, open the hydraulic shut-off valve.
H
hernandezjosephSep 5, 2025
What to do if the engine stopped because of a sloping surface in Metso Outotec Industrial Equipment?
- T
  Timothy LiuSep 5, 2025
  If the engine is not running properly or it suddenly stopped on your Metso Outotec Industrial Equipment while driving on a sloping surface or onto a trailer truck, the automation system may have stopped the machine because the hydraulic fluid or the coolant level is too low. Correct the inclination angle of the machine if it is too large.
S
Sara SmithSep 8, 2025
What to do if track drive does not work because of control device connection order in Metso Outotec Industrial Equipment?
- J
  Jessica BrownSep 8, 2025
  If the track drive is not working on your Metso Outotec Industrial Equipment, and the drive control device or radio control device was connected before starting the engine, reconnect or reactivate the control device.