Need help?Do you have a question about the Metz mecastudio BL-200 and is the answer not in the manual?
Steps for carefully removing the studio flash unit from its packaging.
Procedure to verify all items are present and undamaged upon delivery.
A sequential guide to safely set up and begin using the studio flash unit.
Instructions for adjusting the flash brightness level of the unit.
Guide to control and adjust the brightness of the modelling lamp.
How to enable or disable the audible tone indicating flash readiness.
Using the studio flash unit in a slave mode triggered by camera flash.
Connecting and operating the unit using a synchronous cable.
Triggering the studio flash unit wirelessly using a radio module.
Inspection of connecting cables and connectors for damage before use.
Safe procedures for cleaning the exterior and optical components.
Procedure to fully charge the capacitor for optimal output.
Instructions for safely replacing the unit's flash tube or modelling lamp bulb.
Guide to replacing a defective miniature fuse with a spare.
List of available replacement parts for the studio flash unit.
Catalog of optional accessories compatible with the unit.
General| Light Type | LED |
|---|---|
| TLCI | ≥98 |
| Dimmable | Yes |
| Adjustability | Tiltable |
| Battery Life | Not applicable |
To Next Page
