Meyer Sound LEOPARD User Manual

CHAPTER 1: INTRODUCTION
12
NOTE: For Native mode to work properly, the
source signal must be correctly configured
with the appropriate gain structure.
CAUTION: Make sure that all cabling for
looped loudspeakers is wired correctly (Pin 1
to Pin 1, Pin 2 to Pin 2, and so forth) to prevent the
polarity from being reversed. If one or more loud-
speakers in a system have reversed polarity, fre-
quency response and coverage will be significantly
degraded.
!

Meyer Sound LEOPARD Specifications

General

Amplifier Type	Class D
High Frequency Driver	1 x 3-inch compression driver
Input Connector	XLR 3-pin (audio only)
Connectors	Neutrik NL4
Low Frequency Driver	2 x 9" cone drivers with 2" voice coil