PV SERIES
INSTALLATION AND INSTRUCTIONAL MANUAL
xxxxx-xxx-xx month/day/year
PV SERIES
(Sequence of Operations)
F. TO TURN ENGINE OFF (With or without conveyor
running).
1. TURTLE Push throttle slow button to
reduce setting to idle (this prevents
engine flooding and hard starting).
2. STOP Push STOP button and hold
5 seconds.
G. Do not attempt to start the engine
with the conveyor engaged.
H. Close fuel shut off valve on engine if
unit is to be transported while not
running.
1. As with all power equipment, safety is the number
one concern.
2. Do not operate this equipment until you fully
understand how it functions.
3. Before starting engine, be sure that no one is near
the rear of the unit and that no one is inside the
unit!
4. Do not start the engine or engage the conveyor
(which is interconnected to the spinner) until
everyone is clear from moving parts and flying
material from the spinner.
A. ON/Off System power activated (ready to
start). Spreader engine not running.
Spreader conveyor is not engaged.
B. START (Engine Only)
1. Open fuel shut off valve on engine.
CHOKE (Cold engine.) Hold down for
5 seconds to move the throttle
actuator to the choke position.
TART Hold down button until engine
starts.
URTLE Decreases throttle speed - adjust
asengine warms up. Will stop the
choke function.
R
ABBIT Increases throttle speed.
C. TO ENGAGE SPREADER CONVEYOR
1. CONVEYOR Push CONVEYOR switch only after
you are sure no one is in the
hopper
or near the spinner!
D. TO CONTROL CONVEYOR SPEED
1. RABBIT Hold RABBIT to increase speed.
Note
DO NOT hold switch in HI position
after the desired RPM is achieved
or
you will choke and/or stall the
engine.
2. TURTLE Hold TURTLE to decrease speed.
E. TO DISENGAGE SPREADER CONVEYOR
1. CONVEYOR Push conveyor button.
2. S
3. T
Standard
To Next Page
Loading...
