INSTALLATION AND INSTRUCTIONAL MANUAL
xxxxx-xxx-xx month/day/year
PV SERIES
pole DC motor that can output 180 amps for up to 5 seconds and a continuous amperage
of up to 80 amps. The speed or RPM control is done by providing the user 5 outputs,
RPM feature the runs the motor full speed for 6 seconds and then automatically shuts off
and an E-Stop.
include:
• Automatic shut down if motor is locked up. How this is done is if the receiver
senses a current draw of more than 180 amps for more than 10mS the unit will
shut down from 1 to 30 seconds.
• Automatic shut off if the current draw does not drop below 80 amps after 5
seconds. Once again, the receiver will shut down for 1 to 30 seconds.
Typical Wiring Connection Diagram
12VDC
MOTOR
RECEIVER
PWM OUT
(GREEN
WIRE)
GROUND DIRECT
FROM POWER
SOURCE (BLACK
WIRE
12VDC IN
(RED
WIRE
DC POWER
SUPPLY
FROM
REGULATED
12VDC
SOURCE
For use with Electric Packages
The Variable speed Wireless DC Motor Controller provides RPM control for a single, 2
approximately 1/5 of the maximum motor RPM. The also incorporates a full
To protect the motor and electronics, the
variable speed has built-in safety circuits. These
Variable speed
Meyer Products Variable Speed
To Next Page
Loading...
