PV SERIES
INSTALLATION AND INSTRUCTIONAL MANUAL
xxxxx-xxx-xx month/day/year
PV SERIES
OPERATION:
Shown above is a typical transmitter for wireless operation of a 12VDC motor. The
button functions are as follows:
1. ON/ This button turns on the receiver unit and will allow the receiver to function.
It also will stop the unit, but does not shut down the receiver.
2. #1/ Slow speed setting of approximately 1/5
th
of full motor speed.
3. #2/ Speed setting or approximately 2/5
th
of full motor speed.
4. #3/ Speed setting or approximately 3/5
th
of full motor speed.
5. #4/ Speed setting or approximately 4/5
th
of full motor speed.
6. #5/ Full Speed.
7. Blast/ A timed 6 to 8 second full speed with auto shut down.
8. OFF/ Shuts down the receiver unit. Must be turned on using Button #1
Programming Transmitter to Receiver:
The following are the step by step procedures for setting the unique address between the
transmitter and receiver or adding extra transmitters to the receiver (up to 40
transmitters).
1. Disconnect green PWM wire from motor.
2. On the backside of the Transmitter, use a paperclip and insert it in the hole next to
the clear blue window. Once the programming button is depressed, a blue LED
will begin to blink for 15 seconds. Flip the Transmitter over and firmly depress all
8 buttons starting with the ON button within 15 seconds. Now the Transmitter has
acquired a 1 in 16 million address.
3. Next step is to remove the receiver box cover noting the drain hole positions in
the cover. Hook up the Power (red wire) and Ground (black wire) to a 12VDC
power source. Inside the box next to the red LED depress the black programming
VARIABLE SPEED TRANSMITTER
Button #8 (open button)
control speed
Numbered buttons
To Next Page
Loading...
