MFJ 8100K - Page 17

16
 2
- PC-mount 1/8" stereo phone jack [J2,J3]
 1
- Insulated binding post (antenna) [J1]
 1
- PC-mount push-button switch (DC on/off) [SW2]
 1
- 5-position rotary switch (bandswitch) [SW1]
HARDWARE & MISCELLANEOUS
 1
- Pre-drilled printed circuit board
 1
- 9-volt battery snap connector
 1
- 9-volt battery bracket with foam adhesive strip
 1
- Aluminum chassis (bottom section)
 1
- Aluminum cover
 2
- 4-40 machine screws
 2
- 4-40 standoff spacers
 2
- 4-40 self-locking machine nuts
 1
- 10-32 machine screw (for ground connector)
 2
- 10-32 self-locking machine nuts
 2
- 10-32 steel washers
 1
- 10-32 wing nut
 3
- 3/8" hex panel nuts (to mount controls and SW1)
 3
- 3/8" steel washers (for controls and SW1)
 2
- Instrument knobs for controls
 1
- Pointer knob for band switch
 1
- Larger (1.25") knob for tuning
 1
- Pointer assembly for tuning capacitor
 8
- Pan-head phillips screws for cabinet assembly
 4
- Rubber bumper feet (self-adhesive)
 1
- Set of hookup wires for jumper, winding L5
 1
- Wire-tie to secure battery snap wires
 1
- Instruction/Assembly manual
REQUIRED, NOT SUPPLIED

9-volt alkaline or heavy-duty battery

Low impedance stereo headphones ("Walkman" type)

Antenna wire
MINIMUM TOOLS REQUIRED

Soldering iron (20 to 30 watts)

Rosin-core solder intended for electronics work

Diagonal cutters or wires nippers

Small or medium phillips screw driver

Pliers or set of nutdrivers

Miniature jeweler-type flat blade screwdriver to adjust C5

Set of Allen hex wrenches (1/16" & 5/64)