How to fix high voltage on my MG Portable Generator?
If the generator voltage is too high on your MG Portable Generator, it could be due to: * The engine speed being too high; have it adjusted to the rated speed, max. voltage 240 Volt. * A defective speed controller; replace the speed controller.
What to do if the power protection switch trips on my MG Portable Generator?
If the excessive power protection switch has tripped on your MG Portable Generator, it may be caused by: * A defect in the consumer or in the supply cabling. Reset the protection switch. Connect first the supply cabling then the consumer. If the protection switch trips again, have the supply cabling or the consumer repaired. * A defective protection switch; check the protection switch, replace it if necessary.
How do I reset the emergency stop on my MG Portable Generator?
If an EMERGENCY STOP was triggered on your MG Portable Generator, unlatch the EMERGENCY STOP button by turning it clockwise.
What does 'start inhibit' mean on my MG Portable Generator?
The 'start inhibit' message on your MG Portable Generator means there have been too many start attempts in succession, which protects the starter. You must wait 30 seconds before making a further attempt to start the engine.
General| Brand | MG |
|---|---|
| Model | EISEMANN BSKA 14 EV RSS cube |
| Category | Portable Generator |
| Language | English |
To Next Page
