MGE UPS Systems SAM 12 - Maintenance; Daily Procedures

SA 12, SA 14, SA 15 and SA 16 – UK
Operation and Maintenance Manual
Manual 117 Issue 15 Page 12 of 24
4. MAINTENANCE
Warning! Other than for routine daily procedures, any maintenance or repairs to MG
Electric products must be carried out by fully trained and qualified engineers
(EBME) or an authorized MG Electric dealer. Such persons are to be familiar
with the relevant standards, rules, accident prevention regulations, and
operating conditions as a result of their training, experience, and instruction.
They are qualified to carry out the required activities and in doing so recognize
and avoid potential hazards. All testing on SA units should be in accordance
with ISO 10079-1
Warning! No modification of this equipment is allowed.
Warning! Contamination may be present on any components. When cleaning or
replacing any part of the SA unit appropriate protective clothing and gloves
MUST be worn to avoid contamination. Disposal of contaminated parts must
be according to local protocols.
Warning! Any dismantling and re-assembly of this equipment - for whatever purpose -
must be followed by testing in accordance with the manufacturers’
recommendations as specified for Monthly maintenance.
Warning! Isolate the SA unit from the mains power supply before carrying out any
maintenance or repairs. Electrical isolation of the SA unit is by removal of the
mains power cable from the mains power supply.
4.1 Daily Procedures
• The external filter capsule should be changed after any of the following:
o Each day’s use.
o If it becomes wetted by froth.
o After aspiration of any infective material.
o Before being used on a new patient.
• Examine the collection container for damage. Replace if necessary.
• Examine the external tubing for ageing, damage, or contamination. Replace if
necessary using equivalent tubing (∅6mm I/D with 3mm minimum wall thickness).
Vacuum connector
to collection
container
External Filter
Filter Mount
External tubing