MGI ZIP X1 User Manual 1716
9.0 Preventative Maintenance Program
To properly provide for the continued operation of your MGI
ZIP caddy, MGI has introduced its Preventative Maintenance
Program [PMP]. The PMP consists of work to be carried out by
both the owner and authorized service centres. To properly
maintain the warranty of your MGI motorized caddy, it is essential
that this work is carried out. If the work carried out by the
authorized service center is to replace parts that are part of the
maintenance schedule, the owner will be charged for the parts
and labor. If the work to be carried out is part of warranty, MGI will
bear the cost.
9.1 Cleaning Your MGI ZIP Caddy [See Maintenance Schedule]
• For years of good operation, your caddy requires care and
attention.
• Keep your caddy clean by using a cloth with warm water
and a mild detergent.
• Do not hose down your caddy under any circumstance, as
the caddy has electronic components.
• Ensure that the seat stem bracket is free from sand.
• Do not submerge your caddy in water as it will cause
irreparable damage.
• Clean the caddy battery base when the battery is removed
from the caddy.
9.2 Rear Wheel Axles Maintenance [See Maintenance Schedule]
The rear wheel stub axles need to be lubricated regularly. Remove
the rear wheels by depressing the spring clip and at the same
time pull off the wheel. Apply Petroleum Jelly or light grease to
the stub axles. Use a very small amount as the grease can attract
sand. If you play in sandy conditions you should clean the axle
and regrease fortnightly.
9.3 Upper and Lower Bag Strap Maintenance [See Maintenance
Schedule]
The bag straps should be replaced as per the Service Schedule.
The upper bag strap can be replaced by:
• Removing the left and right hand straps form the upper bag
support
• Undo and remove the screws holding the strap in position on
the bag support
• Remove and replace both bag straps
• Insert bag strap securing screws.
9.4 MGI Service Schedule
It is the owner’s responsibility to ensure that all periodical checks,
necessary adjustments and services are carried out. If in doubt
please contact the MGI service center on 1300 644 523. Any work
performed on your caddy should be recorded on your service
record (see page 18) regardless of the work.
MGI ZIP X1 Monthly
6
Monthly
Every
2 yrs
Every
3 yrs
Wipe down the
caddy with a warm
cloth after each use
[do not hose]
BO
Lubricate rear wheel
stub axles
BO
Check and tighten
nuts and bolts
BO
Check and tighten
handle pivots
BO
Check alignment of
caddy – ensure that
it runs straight
BO
Replace Speed
Controller and On/
Off switch assembly
BO /SC
Replace rear and
front wheels
BO
Replace upper and
lower bag straps
BO
BO = Caddy owner can carry out this work
SC = Charged work to be carried by approved service center
BO/SC = The six monthly service can be completed by either an
authorized service center or the owner of the caddy.
To Next Page
Loading...