Fuel flow rate
Please configure your EFIS for a K-factor of 7000 using the “turbine” option.
Manifold air pressure
No EFIS configuration is needed. Please set manifold calibration to zero unless you have an
accurate reference source. In that case you may use the calibration as needed.
Note: This item requires an optional engine monitoring module available from UL Power.
Oil pressure
Please configure your EFIS for “Probe type: Linear 0-5V”. Pressure sender range is 10 bars.
Oil temperature
Please configure your EFIS for “Probe type: LM335 semiconductor”.
EGT 1,2,3,4,5,6
No configuration is needed other than the usual range settings. The EGT senders are
mapped to channels TC1,2,3,4,5 and 6.
Note: These items require an optional engine monitoring module available from UL Power.
CHT 1,2,3,4,5,6
No configuration is needed other than the usual range settings. The EGT senders are
mapped to channels TC7,8,9,10,11 and 12.
Note: These items require an optional engine monitoring module available from UL Power.
Engine ambient temperature
This signal is mapped to AUX2. Configure AUX 2 as LM335 probe.
Throttle position
A value from 0-100. This value can be observed in the diagnostics.
Engine ambient pressure
This value can be observed in the diagnostics. It is displayed in Hpa.
Fuel pressure
Please configure your EFIS for “Probe type: Linear 0-5V” and a suitable range for the fuel
pressure (from your engine specifications).
To Next Page
Loading...
