MHZ SOLIX EXTERNAL - English Installation Instructions: Initial Steps; Unpacking and Initial Inspection; Window Preparation and Blind Insertion

Subject to technical changes I Edition 04.2022
36
DE
FR
NL
EN
ES
IT
Installation instructions
Solix external roller blind
Required tools:
Size 1
1.
Unpack blind unit and check for any damage.
Do not install any damaged unit. Consult the specialist retailer rst.
As climbing aids use only ladders that have a sufciently high load-bearing capacity and are undamaged.
They must be steady and provide adequate grip.
2. Fully open window
3. Push Solix from inside into the window frame.
First
1
place in position at the top and then
2
push in at the bottom.
n the version with an insect screen handles are tted for this.
Note: If the Solix frame is too small and there is insufcient unit surface area available around it against the window
frame (at least 4 mm on each side), the Solix may not be installed. There is a danger of the Solix
falling out and causing serious injuries or damage.
Important information for the installer and user
1
2