When the light on, short press
any zone of " " 3 times
within 3 seconds
Linking Instructions
If the light not blink slowly, the linking failed, Pls switch off the light
again, and follow the above steps again.
Switch off the light,
after 10 seconds
switch on again
1 2 3
Power
The light blink 3 times
slowly means the linking
is done successfully.
Power
Link/Unlink
button
The light can be working after
linking with the remote controller.
When the light on, short press
" " 5 times within 3 seconds
Unlinking must be the same
zone with the Linking
Unlinking Instructions
If the light not blink quickly, the unlink failed, pls switch off the light
again, and follow the above steps to unlink again.
Switch off the light,
after 10 seconds
switch on again
1 2 3
Power
The light blinking 10
times quickly, means the
unlinking successfully.
Power
Link/Unlink
button