1450
12
inlet filter cleaning instructions
33. Continue guiding cord back and
forth until entire cord is on the
reel.
A clogged or partially clogged noz-
zle can cause a significant reduction
of water coming out of the nozzle
and cause the unit to pulsate while
spraying.
To clean out the nozzle:
∙ Turn off the unit.
∙ Turn off the water supply.
∙ Relieve any pressure trapped in
the hose by squeezing the trig-
ger 2 - 3 times.
∙ Separate lance from gun.
∙ Rotate nozzle to the narrow
stream setting. This opens up
the fan blades.
∙ Using the tip cleaner included,
insert it into the nozzle hole and
move back and forth until debris
is dislodged.
∙ Remove additional debris by
back-flushing water through
the nozzle. To do this, place end
of garden hose (with water run-
ning) to tip of nozzle pushing
water and debris out the back
opening of the lance.
34. Push handle in to lock reel.
nozzle cleaning instructions
A clogged filter may cause pulsate
spraying or reduction of flow.
CHECK AND
CLEAN THE
FILTER AFTER
EVERY USE
power cord reel instructions
(power cord reel is for storage only)
31. Unlock Power Cord reel by
pulling handle out.
NOTE: Power Cord reel is
for storage only.
32. Put the NEMA plug inside the
power cord reel and with the
other hand turn slowly to start
to rewind the power cord.
mpx1450_en.indd 12 22/02/10 09:29
To Next Page
Loading...
