Michelin MPX 1700 - Additional Safety Warnings

operating instructions
mpx
1700
6
important safety nstructions (cont)
Risk of Explosion
‧ ∙ Do not spray flammable liquids.
‧ ∙ The pressure washer must only
be used with clean water and not
flammable detergent.
‧ ∙ Never use in areas containing
combustible powders, liquids or
vapors.
Risk of Electrocution
‧ ∙ Inspect cord before using - do
not use if cord is damaged.
‧ ∙ Keep all electrical connections
dry and off the ground.
‧ ∙ Do not touch plug with wet hands.
If replacement of the plug or
cord is needed, use only identi-
cal replacement parts.
∙ Do not spray the water jet onto
electrical apparatus and wiring.
∙ This product uses double insu-
lated parts - when servicing use
only identical replacement parts.
∙ Read instruction manual before
using.
Risk of Injection or Severe Injury
‧ ∙ High pressure. Keep clear of
nozzle. Do not direct the water
jet towards people or animals. In
case of injury seek medical aid
immediately.
‧ ∙
Never put hands or fingers over the
spray tip while operating the unit.
‧ ∙ Never try to stop or deflect leaks
with any body part.
‧ ∙ Always engage the trigger safety
latch in the safe position when
spraying is stopped even if only
for a few moments.
‧ ∙ Point gun in safe direction. Unit
will start spraying when trigger
is squeezed if ‘on/off’ switch is
in “ON” position.
‧ ∙ Discharge pressure - When ‘on/
off’ switch is in “OFF” position,
pressure may still exist in unit. To
discharge pressure, point gun
in a safe direction and squeeze
trigger.
‧ ∙
High pressure - gun kicks back -
hold gun with both hands.
‧ ∙ Keep hose away from sharp ob-
jects. Bursting hoses may cause
injury. Examine hose regularly
and replace if damaged. Do not
attempt to mend a damaged
hose.
‧ ∙ Use only detergents specifically
formulated for pressure wash-
ers. Always follow detergent
manufacturer’s label recommen-
dations for proper use of deter-
gents. Always protect eyes, skin,
and respiratory system from de-
tergent.
‧ ∙ For either indoor or outdoor use.
Store indoors and where tem-
perature stays above freezing.
‧ ∙ Unplug unit when not in use.
‧ ∙ Pressure washer is not meant to
pump hot water. Do not con-
nect to hot water supply. Max
inlet water supply temperature
122° F.
‧ ∙ Never leave the unit unattended
while it is plugged in.
‧ ∙ Always turn water supply “ON”
before turning pressure washer
“ON”. Running the pump dry
causes damage.
note
mpx1700_en.indd 6 22/02/10 09:05