To Next PageTo Next Page
Need help?Do you have a question about the Michi S5 and is the answer not in the manual?
General| IMD | <0.03% |
|---|---|
| Damping Factor | 350 |
| Channel Separation | >75dB |
| Frequency Response | 10Hz - 100kHz |
| Dimensions | 485 x 238 x 465 mm |
| Input Impedance | 12k Ohms |
| Power Requirements | 230V, 50Hz |
| Power Output | 500W per channel (8 Ohms), 800W per channel (4 Ohms) |
| Weight | 58.9 kg |
Essential safety warnings regarding electrical hazards, water exposure, and internal components.
Advice on ventilation, heat sources, plugs, cords, and accessories for safe operation.
Explanation of safety symbols and compliance with electrical standards.
Details the pin assignments for balanced audio (XLR) connections.
Identifies and illustrates controls and indicators on the front panel.
Shows and labels the various input and output connectors on the rear panel.
Identifies the buttons and their functions on the RR-RH6 remote control.
Illustrates how to connect speakers using a single wire per speaker.
Illustrates how to connect speakers using the bi-wire method.
Shows single wire speaker connection for the M8 model.
Shows bi-wire speaker connection for the M8 model.
Details the balanced (XLR) input connections for the Michi P5.
Details the balanced (XLR) input connections for the Michi S5.
Shows balanced (XLR) input connections for the Michi P5.
Shows balanced (XLR) input connections for the Michi M8.
Illustrates the 12V trigger connections for the Michi S5.
Illustrates the 12V trigger connections for the Michi P5.
Shows 12V trigger connections for the Michi P5.
Shows 12V trigger connections for the Michi M8.
Advises turning off components before making or changing connections.
Recommends turning the volume down before powering on/off.
Explains power ratings and speaker impedance effects on performance.
Advises matching speakers to the amplifier's high power output.
Covers initial setup, power management, and speaker wire safety.
Specifies clearance requirements for heat dissipation and airflow.
Guidance on routing signal and power cables for optimal performance.
Step-by-step instructions for installing batteries in the remote.
Details AC power input, voltage, and direct connection recommendations.
Explains the rear panel master power switch and front panel power button.
Describes the 12V trigger jacks for amplifier control and daisy-chaining.
Explains the amplifier's protection circuits and how they function.
Guides on how to reset the amplifier if protection mode is activated.
Details RCA/XLR inputs and the function of the input selector switch.
Recommends 4-ohm or higher impedance speakers and bi-wire options.
Advises on wire type, quality, and correct polarity for speaker connections.
Details connecting bare wire, lugs, or banana plugs to binding posts.
Describes the dual cooling fans and their automatic speed adjustment.
Explains RS232 control for integration with automation systems.
Details connecting to a network for software updates and IP control.
Overview of front panel display, remote sensor, and key buttons.
Explains how to navigate the setup menu using remote control buttons.
Details network configuration including IP address and standby settings.
Covers display brightness, function, and LED brightness settings.
Details software version, updates, and factory default reset.
Provides solutions for power indicator, no sound, and protection indicator faults.
Detailed technical specifications for the Michi S5 stereo power amplifier.
Detailed technical specifications for the Michi M8 monoblock power amplifier.
