MICODUS MV66 - Page 5

2. Set Data Upload Interval
3. Vibration Alarm
TIMER,T1,T2#
Step 1: Set up a center number for the device:
CENTER,A,CENTER NUMBER#
Step 2: Set up SOS contact numbers:
SOS,A,SOS1,SOS2,SOS3#
Step 3: Set up the vibration alarm way: SENALM,A,M#
M=0/1/2, way of alarming, 0 : Server only, 1: SMS+Server,
2 : SMS+Server+Call, default:2
This means the vibration alarm message will be sent out via server and SMS
A=ON/OFF, default: OFF;
T1 ranges 0/5~18000 or 0(seconds), upload interval
when ACC ON, 0 means no upload, default is 10;
T2 ranges 0/5~18000 (seconds), upload interval
when ACC OFF, 0 means no upload, default is 10;
This command means the tracker will upload every 10 seconds when it
engine is on, and every 3600 seconds when engine is off.
For example:
TIMER,10,3600#
SET TIMER OK
MV66
For example:
CENTER,A,+8613366668888#
SET CENTER NUMBER OK
SOS,A,+8613366667777,+86133
66667778,+8613366667779#
SET SOS NUMBER OK
SENALM,ON,1#
SET VIBRATE ALARM OK
MV66
For example: TIMER,10,3600#
For example: if you want to set up this number as
center number:+8613366668888, the command
should be sent like this: CENTER,A,+8613366668888#
For example: SOS,A,+8613366667777,+8613366667778,+8613366667779#
For example: SENALM,ON,1#
Note: You can set up 3 SOS alarm numbers for the device at the same time
Note: Please put the country code as prefix with the
center number!