6. Electrical Installation
At the back side of the thermoIMAGER TIM you will find two connector plugs.
Please connect the supplied USB cable with the left plug.
The right connector plug is only used for the process interface.
Plug for USB cable
Plug for PIF cable
Fig. 15 Rear side of camera with connectors
6.1 Process Interface
The TIM is equipped with a process interface (cable with integrated electronics and terminal block), which
can be programmed via the software as an Analog Input (AI) and Digital Input (DI) in order to control the cam-
era or as an Analog Output (AO) in order to control the process. The signal level is always 0 – 10 V.
Please make sure that the process interface (electronics within cable as well as industrial interface) is pow-
ered separately (5 - 24 VDC).
> With no external power supply the PIF will not work
To Next Page
Loading...
