LED Indicators
GREEN – flashes every time a pulse is sent to the coils
RED – brief flash at the end of each mode, but if RED flashes many times or stays ON, that means device fault. Try this:
make sure coils are plugged in correctly and fully, test coils with hexagonal tester, turn power OFF and allow to cool.
YELLOW – flashes only during REST periods (available in selected protocols). No pulses are sent to the coils when flashing.
COPYRIGHT © 2017 Micro-Pulse LLC All Rights Reserved Worldwide
Coil Tester (above). For instructions, see:
https://www.youtube.com/watch?v=Fy_p2ZtW03M
To Next Page
Loading...