Micro Solutions Backpack - Playing Audio CDs; Playing An Audio CD Under Windows 3

4) Restart the computer by holding down CTRL, ALT, and DEL.
Note: If backpack is connected and powered on, but still reports the error “A
backpack CD-ROM Drive was not found...” during boot, refer to the Trou-
bleshooting section (Appendix A) of this User’s Guide. Do not install the NON-
STOP option since it will only suppress the error and will not correct the con-
flict.
Playing Audio CDs
To play audio CDs on the backpack CD-ROM drive, you can use Microsoft
Windows 3.1 or above, Windows 95 or any suitable DOS audio player software.
Playing An Audio CD Under Windows 3
Before using audio CDs with Windows, you must inform Windows that you
have a CD-ROM drive with audio capability attached. Perform the following
steps from the Windows main screen:
16)Insert an audio CD in the backpack drive.
17)Open the Program Manager window.
18)Double click on the MAIN icon in the Program Manager window.
19)Double click on the CONTROL PANEL icon in the MAIN window.
20)Double click on the DRIVERS icon in the CONTROL PANEL window.
21)A list of installed drivers will appear. If the list contains [MCI] CD Audio,
the driver has already been installed and you should click on the CAN-
CEL button and skip the next steps. If the driver is not installed already,
proceed with the following steps.
22)Click on the ADD button. A list of drivers will then appear.
23)Click on [MCI] CD Audio and then click on the OK button. Windows may
prompt you to insert one of your Windows installation diskettes at this
point. If it does, insert the diskette and follow the instructions on the
screen.
24)Exit Windows; then restart Windows to load the new driver.
4 Troubleshooting