Microh LEDBARQX 185 - Safety Warning

Safety Warning
• Every person involved with the installation, operation and maintenance of this
device must be qualied.
• User/installer must follow the instructions of this manual.
• Unqualied persons must not open the housing cover and operate the device,
or the dealer will not accept liability for any resulting defects or problems.
• Protect the device against rain and moisture device with other electrical equipment.
• During move and installation, make sure the device is not stored with metal
parts and other tough materials.
• Always disconnect from the main power sources. Do not install or dismantle
when the device is powered on.
• The minimum distance between light output and the Illuminated surface must
be more than 50cm.
• The device must only be installed on a non-ammable surface. In order to
safeguard sufcient ventilation, please leave 50cm of free space around the
device. Note that heat-sensitive objects may be deformed or damaged by the
emitted heat of this xture.
• During operation, the housing may become very hot! Do not operate the device
for 15 minutes after switching off.
• The maximum ambient temperature Ta = 45°( must never be exceeded). The
maximum housing temperature Tb = 80°( must never be exceeded).
• This xture is for indoor use.
• Replace any visible cracked protective shields, lters, and lenses.
• The protective shields, lters, and lenses will require weekly cleaning as
smoke “cuid” tends to build up residues, reducing the light output very quickly.
CAUTION!
Never touch the device during operation!
The housing may heat up!
CAUTION!
Never look directly into light source,
as sensitive persons may suffer from an epileptic shock.
Caution!
• Unqualied person involved with installation, operation and maintenance of
this device is prohibited.
• lf any of the above mentioned problems happen, or unknown problems happen,
please contact manufacturer or distributor for assistance.