Microh LEDPRO64RGBW - Page 4

3

- The fixture’s warranty will be voided if there are any malfunctions from not following the user manual or any illegal
operation (shock short circuit, electronic shock, lamp broke, etc.)
- This unit has a total of 9 operating modes: Static Colour Select, 4 Colour Change, 15 Colour Change, 4 Colour
Fade, 15 Colour Fade, Auto, Sound Active, Slave & DMX
- To initialize extra factory setting press MODE & UP buttons at the same time while program is on Auto mode.
- To keep the display on at all times, press MODE & UP buttons simultaneously. To have the display turn off after 20
seconds press MODE & DOWN buttons simultaneously.
STATIC COLOUR SELECT MODE
- Press MODE button, select “C.××”, Press UP or DOWN to select static colours 0-15.
4 COLOUR CHANGE
- Press MODE button, select “J ××”. Press UP or DOWN to select the colour changing speed from 1-99. (From slow to
quick)
15 COLOUR CHANGE
- Press MODE button, select “J .××”. Press UP or DOWN to select the colour change speed from 1-99. (From slow to
quick)
4 COLOUR FADE
- Press MODE button, select “F ××”. Press UP or DOWN to select the colour fade speed from 1-99. (From slow to quick)
15 COLOUR FADE
- Press MODE button, select “F .××” .Press UP or DOWN to select the colour fade speed from 1-99.(From slow to quick)
AUTO
- Press MODE button, select "A.- -". The 15 colour change program and 15 colour fade program run alternatively. UP or
DOWN buttons do not function in this mode.
SOUND ACTIVE
- Press MODE button, select "S.××". Press UP or DOWN to select sound-active sensitivity grade 0-31.0 is off ,1 is the
lowest sensitivity,31 is the highest sensitivity.
SLAVE
- Press MODE button, select "S.L.A." UP or DOWN buttons do not function in this mode.
DMX
- Press MODE button, select slave mode. DMX address"×××" Press UP or DOWN to select DMX address. You can set
512pcs address from 001 to 512.It will flicker when there is no controller signal.
