Top view of the soundbar
Back view of the soundbar
Function Instruction
Front view of
remote control
3
System Connection
4
1.St-by:standby
2.Input: select input mode
3
.Treble+/- speaker
system
+/- speaker
system
6.Volume -/+:adjust the speaker system's
volume to your desired level
.Mute: press the key to make the system
in muting
4:
5.Bass :
adjust the treble of
adjust the bass of
BASS
MUTE
VOL
ST-BY
INPUT
TREB
2
4
3
6
1
1.Input mode: select Input mode
2 Volume -/+: adjust the speaker system's
volume to your desired level
3.Standby
.
4.Power: press the switch on or off
5
1.Input 1: connect to the audio source
2.Input 2: connect to the audio source
3.S.W output: connect to the woofer speaker
4.Fuse
5.Power cord
1
2
3
4
5
1 2 3 4
. Connect the woofer speaker to S.W OUT jack on the back of the soundbar.
2. Connect one end of the audio cable to AUDIO INPUT 1(AUDIO INPUT 2) jacks on the back of the
soundbar, the other end to the appropriate output jacks of audio source.
3.
4. Check the connection and make sure every cable is correctly connected, then connect power plug
to the right AC outlet. The shape of the plug and power outlet depends on the using country.
Statement indicating that the socket-outlet shall be installed near the equipment and easily
accessible.
The highest environmental temperature suitable for this product is 40 C.
System Connection(as diagram2):
1
o
Remarks: the jacks and plugs are color-coded. Be sure to attach each color-coded plug to a
matching color coded jack.
■
■
■Please note the correct placement of speaker is shown in the above picture.
Woofer
Soundbar
Connect t , ,etc)DVDo audio source(TV
AC
AC IN
FUSE
T400mAL250V
S.W OUT
RL
INPUT1
INPUT2
INPUT1
INPUT2
Operation for audio input interface
on back panel
Wall mounting accessories Wall mounting accessories
■If there are needs, wall mounting is also available for soundbar.
Diagram1
Diagram2
80-S335-97-0001-01 2009-01-06
To Previous Page
Loading...
