2
Precautions
Model No. Description
Connection
BSP (Female parallel)
Nominated Max.
Working Pressure
Temperature Rating
W10PR
10" Standard Filter Housing (includes
spanner, mounting bracket and xings)
3/4"
(20mm)
860kPa
Working:
0 - 40ºC
Ambient:
0 - 50ºC
W10J25MM
10" Jumbo Filter Housing (includes
spanner, mounting bracket and xings)
1"
(25mm)
W20J25MM
20” Jumbo Filter Housing (includes
spanner, mounting bracket and xings)
WARNING: Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before or after
the system. Systems certied for cyst reduction may be used on
disinfected waters that may contain lterable cysts.
CAUTION: Filter must be protected against freezing, which can cause
cracking of the lter and water leakage.
CAUTION: If your uid system is suspected to have high night time pressures
or occasional high pressure surges/water hammer (which can be induced
by the quick acting valves in equipment such as washing machines and
dishwashers) or the pressure is regularly/typically over 100psi / 680kPa - then
it is recommended that an anti-hammer device (before/after) or a pressure
reducing valve be installed before the lter housing.
CAUTION: The rubber O-ring provides the water-tight seal between the cap and
the bottom of the housing. It is important that the O-ring be properly seated in
the groove below the threads of the housing or a water leak could occur.
CAUTION: Because of the product’s limited service life and to prevent costly
repairs or possible water damage, we strongly recommend that the bottom of
all plastic housings be replaced every ten years. If the bottom of your housing
has been in use for longer than this period, it should be replaced immediately.
Date the bottom of any new or replacement housing to indicate the next
recommended replacement date.
To Next Page
Loading...