15
Automatic Blood Pressure Monitor Instruction Manual www.microlife.com
If problems occur when using the device, the following points should be checked,
and if necessary, the corresponding measures should be taken.
Malfunction
The display remains empty when
the instrument is switched.
Batteries have been in stalled.
The pressure does not rise although
the pump is running.
The instrument frequently fails to
measure blood pressure values, or
the values measured the are too
low (too high).
Every measurement produces a
different value although the
instrument functions normally and
the values displayed are normal
The Blood pressure values
measured differ from those
measured by the doctor.
Remedy
1. Check the polarity of the batteries (+/-)
2. If the display is erratic or unusual, remove ebatteries
and re-install new batteries.
1. Check the connection of the cuff tube and connect
properly if necessary.
1. Ensure the cuff fits correctly.
2. Make sure that the cuff is not fitted too
tightly.Ensure tight clothing such as a a rolled-up
sleeve isn’t exerting pressure on the arm above the
measuring position. Take off articles of clothing if
necessary.
3. Measure blood pressure again in complete peace
and quiet.
1. Please read the following information and the points
listed under (Common sources of error.) Repeat the
measurement.
1. Record the daily development of the values and
consult your doctor about them.
• Please note: Blood pressure fluctuates continually so
successive measurements will show some variabiliey.
To Next Page
Loading...
Need help?
General
