www.microlife.com Automatic Blood Pressure Monitor Instruction Manual
14
Error messages/malfunctions
If an error occurs during a measurement, a long beep followed by two short beeps
is generated and the LCD displays the corresponding error code.
Possible cause
● No pulse has been detected.
● Unnatural pressure impulses
influence the measurement
result.
Reason:The arm was moved
during the measurement.
● The inflation of the cuff takes too
long. The cuff is not correctly
seated.
● The difference between systolic
pressure and diastolic pressure is
too far away from acceptable
and reasonable.
● Due to unstable conditions
during measurements, it is not
ssible to calculate an average
result.
● Low battery
Error
Err 1
Err 2
Err 3
Err 5
Err 6
4.4
Remedy
● Ensure that the cuff is being worn
correctly,and that you have your
arm at the heart level.
● Avoid unnecessary movement or
talking.
● Ensure that the cuff is being worn
correctly.
● Ensure that the cuff is being worn
correctly and that you have been
inactive for a sufficient time before
marking the measurement.
● Avoid unnecessary movement and
talking.
● Replace batteries.
To Next Page
Loading...
Need help?
General
