6
5. User Selection
This blood pressure monitor allows you to store the results for 2 indi-
vidual users. In addition, there is a guest mode, in which the results
are not stored.
Alternating between 2 users or the guest mode
6. Data Memory
At the end of each measurement, this instrument automatically
stores the result, including date and time.
Viewing the stored values
Press the M-button 5 briefly, when the instrument is switched off.
The display first shows «M» AL and then a value, e.g. «M 17». This
means that there are 17 values in the memory. The instrument then
switches to the last stored result.
Pressing the M-button again displays the previous value. Pressing
the M-button repeatedly enables you to move from one stored value
to another.
The user symbol AP or AQ indicates which user's memory is being
displayed. To change the user, please follow the instructions above.
Memory full
Clearing all values of an individual user
The following procedure applies for the selected user (AP or AQ).
Information for the doctor on frequent appearance of the
Arrhythmia indicator
This instrument is an oscillometric blood pressure monitor that also
analyses pulse frequency during measurement. The instrument is
clinically tested.
The arrhythmia symbol is displayed after the measurement, if pulse
irregularities occur during measurement. If the symbol appears more
frequently (e.g. several times per week on measurements performed
daily) we recommend the patient to seek medical advice.
The instrument does not replace a cardiac examination, but serves
to detect pulse irregularities at an early stage.
1. While the unit is switched off keep the time button 6 pressed for
3 seconds until the user symbol AP or AQ starts to flash.
2. Press the M-button 5 to change between user 1, user 2 and the
guest mode.
3. Confirm the selection by pressing the start button 1.
)
In the guest mode no memories are stored or displayed.
The maximum memory capacity is 99 results for each user.
From this point onwards, a new measured value is stored by
overwriting the oldest value.
To Next Page
Loading...
Need help?
General
