Microlife FR1MF1 - 5. Set Date, Time and Beeper Functions

6
FR1MF1
EN
mode icon (body or object) will be displayed.
•
Measurement complete
AL
:
The reading will be shown on
the display
3
with the
«°
C
»or«°
F
»
icon and the mode icon
steady.
The unit is ready for the next measurement as soon as the
«°C» or «°F» icon is ashing again.
• Low battery indicator
AO
: When the unit is turned on, the
triangle icon will keep ashing to remind the user to replace the
battery.
5. Set Date, Time and Beeper Functions
• After the new batteries are tted, the year number ashes in
the display
BP
.
You can set the year by pressing the START
button
4
.To conrm and then set the month, press the M button
8
.
• Press the START button
4
to set the month. Press the M
button
8
to conrm and then set the day.
• Follow the instructions above to set the day, 12 or 24 hours
System mode, hours and minutes.
• Once you have set the minutes and pressed the M button
8
,
the date and time are set and the time is displayed.
• If you want to change the date and time, press and hold the
M button
8
down for approx. 3 seconds until the year number
starts to ash
BP
.
Now you can enter the new values as
described above.
• Clicking the ON/OFF button
5
during time setup(after battery
insertion) will remove the device from time setting Mode, the
LCD will show Date/ TIME icons respectively with “--:--”After
that press the ON/OFF button
5
to start the test or if no further
action is taken within 20 seconds, the device will automatically
turn off.
• When the device is switched off, press and hold the ON/OFF
button
5
for 5 seconds to set the beeper
BQ
.
Press the ON/
OFF button
5
to turn the beeper on and off. The thermometer