5
12. Press the time switch again to confirm all
settings. Date and time are now stored, the
clock starts running and the monitor switches
to «ready» state condition which enable your
first measurement.
13. Close the data compartment.
Please note:
• If you hold down the arrow key for more than 2 seconds it speeds up.
•Date /time can also be set easily from computer when you run the Microlife
Asthma Analyser Software.
4. Carrying out a Measurement
• When different people use this meter their individual readings cannot
be assigned to different users when the data is stored.
• If time/date is not set, measurements can not be performed.
• If another person intends to use the device permanently, all data from the
previous user should be erased as explained in this manual.
• In case another user has already used the monitor, we recommend disinfecting
the measuring tube as explained in this manual. In this case we also
recommend that each user uses a new mouthpiece. Extra mouthpieces can be
ordered through your Microlife dealer.
1. Press the ON/OFF button to turn the monitor
on. At first, the last result of the memory is
shown («0» if there are not yet data) and then
the device indicates «READY» for a measure-
ment by two short beeps and blinking arrows.
2. You can perform the measurement while
standing or sitting upright. For better compa-
rison of your data you should always perform
the measurement in a similar position.
3. Hold the monitor with both hands on the two
rubber areas (compartments).
To Next Page
Loading...
Need help?
General