Microlife THERMO+ - Managing Measurement Data; Saving and Deleting Data; Viewing and Sharing Data

EN8
Managing the Measurement Data
Saving Data
• Press «Save» to store the measurement results. If you do not wish to keep a
measurement, press «Cancel».
• To store measurement results from another thermometer, go to «Manual
Input».
☞
The amount of data saved depends on the memory capacity of your iOS
device. A warning message will appear when the memory is full. Delete old data
to save new data.
Deleting Data
• Delete Individual Data: Go to «Report» and press «Edit».
• Delete All Data: Go to «Settings» and press «Reset Data».
Viewing Data
Go to «Report» to view data.
• Viewing Individual Data: Swipe the screen vertically to see data taken in
the same month. To view data taken in different months, swipe the screen
horizontally.
• Viewing Data in a Line Graph: Turn the iOS device horizontally. To view data
in a specic timeline, choose the intended period of view.
1D - One day
1W - One week
1M - One month
All - All measurements stored
Sharing Data
Go to «Report» and press « » to share data*.
*Data is shared via email in CSV format. To use this function, an email account
must be set up in your iOS device and an Internet connection is needed.