MicroPROGEL TC543 - Sect. 7) Setting the Timer for the Delayed Running of the Cycle

MicroPROGEL
______________________________________________________________________________________
______________________________________________________________________________________
http://www.microprogel.it
info@microprogel.it
10
this point, the “TIME” light turns on, the decimal between the hour and minute digits will
flash, and the lights to the sides of the and
STOP
START
button will blink.
When the time has elapsed, the controller will automatically start the selected cycle, by
going into “START” mode.
To stop the countdown and return to STOP mode, press again.
NOTE:
 START mode can be accessed at any moment, without waiting for the end of the delay
time, by pressing the
STOP
START
button.
 The time displayed can be increased or decreased using the and buttons.
WARNING: changes made in this way to the start delay time are not saved, and are
only valid for the timer in progress.
Sect. 7) Setting the timer for the delayed running of the cycle
To permanently change the delay time for all successive timer operations, press and hold
the button for at least one second. Once the value displayed on the MAIN display
starts to flash, change the time value by entering the new time, and confirm using the
Enter
button.