WEB PAGES (cont’d)
B. INFORMATION
1. POINT-TO-POINT HOST AP WEM
The information page provides the details of how the Single-Point Host WEM is configured.
Access Point Name: In most cases, the Access Point, or Host, is the receiving unit
Bridge Name: The subscriber or client unit is the transmitting device
MAC Address: Individual Ethernet device identification code
Firmware Version: The latest firmware version is 6.4.0P (7.01)
Current Channel: Refer to “Rotary Switch Position” for actual frequency channel
Turbo Mode:
0= default (off), 1 or 2= on, both units must be on channel 3,6 or 8 to turn turbo mode on
Rotary Switch Pos: Indicates what channel the software has determined that has been enabled
25.5dBi Jumper: “On” for: MLWES-30. Client “on” for: MLWES-D6 or MLWSU-DI
17.7dBi Jumper: “On” for: MLWES-2-4. Client “on” for: MLWSUP
Security: WPA AES 128 bit is standard default, WEP can also be enabled
IP address:
Shows the IP address of the connected WEM and can be changed as desired
- 10 -
To Next Page
Loading...