WEM SPECIFICATIONS
RF Modules
RF SECTION
Power Output 1 W EIRP @ 5.3 GHz (maximum)
50 W EIRP @ 5.8 GHz (maximum)
Transmitting Frequency 5.250 – 5.350 GHz (U-NII-2)
5.725 – 5.825 GHz (U-NII-3 / ISM)
Channel Capacity 8 non-overlapping channels
5.3 GHz Band - 5280, 5300, 5320
5.8 GHz Band - 5745, 5765, 5785, 5805, 5825
Modulation OFDM
Latency <10 milliseconds
Sensitivity -82 dBm for maximum data rate
Polarization Linear, vertical only
Antenna Type & Gain Omni, 2.5 dBi
Small patch, 7.5 dBi @ 5.3 GHz , 7.8 dBi @ 5.8 GHz
6x6 patch, 12.2 dBi @ 5.3 GHz, 16.7 dBi @ 5.8 GHz
Small patch in 18” dish, 24 dBi @ 5.8 GHz
Beam Width Omni-360°, Small patch-90°, 6x6 patch-24° & 18” dish-8°
Data Throughput Rate Up to 20 Mbps - standard mode, 50+ Mbps – Super mode
(3 channels maximum)
FCC ID JRRWES
Industry Canada 4887A-WES
MANAGEMENT
Interface 10/100 Base T, half/full duplex, rate auto negotiated (802.3
compliant)
Frequency Selection Rotary switch – channels 0 – 9
Web Browser Interface User ID/Password, Super Mode, IP Address, WPA2 AES
and WEP Encryption
Access Method Time division duplexing/Time division multiple access
(TTD/TDMA)
Protocols Used IPV4, UDP, TCP, ICMP, Telnet, HTTP, FTP, SNMP
Network Management HTTP
MECHANICAL
Physical Environmental, sealed, billet aluminum, powder coated
housing with UV stabilized PVC radome
Dimensions 3.6” x 3.6” x 1.75”
Weight 15.2 oz
POWER
Power Requirements 12 - 20 VDC @ 3 W (Reverse voltage protected)
Power Method Power-over-Ethernet (PoE) via power injector module
(“mid-span” compliant – pins 4,5 positive – pins 7,8 ground)
Connector RJ45 – in and out of power injection box
Cable Specifications 100 Meters (328 Feet) on 24 AWG CAT-5 cable
ENVIRONMENTAL
Humidity 95% non-condensing
Operating Temperature -20F to +150F
- 18 -
To Next Page
Loading...