WEM SPECIFICATIONS (cont’d)
Power Injection Module
MECHANICAL
Physical Plastic housing, not weatherproof
Dimensions 2.6” x 2.6” x 1.1”
Weight 2.5 oz
Interface 2 – RJ45 connectors
POWER
Power Requirements 12 VDC 500 mA (wall transformer supplied)
Power-over-Ethernet (PoE) PoE “mid-span” compliant (pins 4,5 positive – pins 7,8
ground)
Indicator LED - red
Connectors DC Jack 2.5 mm x 5.5 mm center positive, 2 – RJ45
ENVIRONMENTAL
Humidity 95% non-condensing
Operating Temperature -20F to +150F
System Ranges
POINT-TO-POINT SYSTEMS_______
Up to 2600 & 3900 Feet Integral directional patch antennas on both WEMs -
5.3 GHz – 2600 ft, 5.8 GHz – 3900 ft
Up to 2 & 4 Miles Integral directional 6 x 6 13-dBi patch antennas on both
WEMs – 5.3GHz – 2 miles, 5.8 GHz – 4 miles
Up to 30 Miles Integral directional patch antennas on both WEMs mounted
in 25 dBi dish antennas - 5.8 GHz only
MULTI-CONNECT SYSTEMS
Up to 500 & 1000 Feet Integral omni-directional patch antennas on both the Host
AP WEM & Client SU WEM - 5.3 GHz - 500 ft, 5.8 GHz –
1000 ft
Up to 1300 & 2600 Feet Integral omni-directional patch antenna on the Host AP
WEM & integral directional patch antenna(s) on the Client
SU WEM(s) - 5.3 GHz 1300 ft, 5.8 GHz - 2600 ft
Up to 2600 & 3900 Feet Integral directional patch antenna on the Host AP WEM &
Client SU WEM(s) - 5.3 GHz – 2600 ft, 5.8 GHz – 3900 ft
Up to 1 & 2 Miles Integral directional patch antenna on the Host AP WEM &
integral directional 6 x 6 13-dBi patch antenna(s) on the
Client SU WEM(s) - 5.3GHz – 1 mile, 5.8 GHz – 2 miles
Up to 6 Miles Integral directional patch antenna on the Host AP WEM &
Client SU WEM(s) – Client SU WEM(s) mounted in 25 dBi
dish antenna(s) 5.8 GHz only
*For product improvement, design and specifications are subject to change without notice.
- 19 -
To Next Page
Loading...