1. Main Board NG
2. Carriage Assembly NG
3. 9 pin button cable NG
4. 19 Pin CCD flat cable NG.
5. Driver installation error.
6. USB cable NG
1. Button Board NG.
2. 9 pin button cable NG.
3. Main Board NG.
4. Scanner S/W Driver NG
1. Carriage Assembly NG
2. Reflective Lamp NG
3. 19 Pin CCD flat cable NG.
4. Main Board NG
5. Power Adapter NG
6. Calibration Ruler
( White Calibration
Stripe ) NG
Scanner is ready ( Scanner Finder find scanner
“ ScanMaker 3880 “ under PC Windows system )
( LED light up in Green steadily )
Color image NG on
photo scanning
OK
Fail
This is an icon of “ Scanner Finder “
with PC Windows system successfully, if scanner finder can find
scanner while scanner link with PC via USB interface well, and then
this icon will show you in resident area of PC Windows system.
This is an icon of “ Scanner Finder “
can not detect scanner has linking successfully, if scanner finder can
not find scanner while scanner link with PC via USB interface, and
then this icon will show you in resident area of PC Windows system.
To Next Page
Loading...
