Microtek ScanMaker 4850 - User Manual

Copyright© 2002 Microtek International, Inc. http://www.microtek.com
I49-003484 A, October 2002
Microtek ScanMaker 4850/4900
Scanner Driver Installation for Windows XP
This insert describes how to load the Microtek scanner driver in Windows XP. You need to perform this
procedure; otherwise, a warning message will appear indicating that your scanner has not passed Windows
logo testing.
The Microtek scanner driver required for Windows XP is included in the Microtek CD-ROM. Follow the
steps below to install the scanner driver.
Select the
first item if
you are using
ScanMaker 4900
Select the
second item if
you are using
ScanMaker 4850
A. Installing the Microtek scanner driver
1. Follow the installation instructions included in the scanner
package to install the scanner. Once the scanner and
software installation is completed, Windows XP displays a
message saying that your scanner has been detected (see
right). Windows will prompt you to locate the scanner
driver.
2. Make sure that your Microtek CD-ROM is placed in the
CD-ROM drive and the default option “Install software
automatically (Recommended)” is selected. Then click
Next>.
3. Once your scanner is detected (see
right), select your scanner model,
then click Next>. The system starts
to copy the relevant files to your
hard disk.
4. When done, click Finish to exit the
“Found New Hardware Wizard”
window.

Microtek ScanMaker 4850 Specifications

General

Scanner Type	Flatbed
Optical Resolution	2400 x 4800 dpi
Color Depth	48-bit
Interface	USB 2.0
Compatibility	Windows and Mac
Maximum Scan Area	8.5 x 11.7 inches
Scan Area	8.5 x 11.7 inches
Maximum Resolution	9600 x 9600 dpi

Summary

Installing the Microtek Scanner Driver

Follow Installation Instructions and Detect Scanner

Follow instructions to install the scanner; Windows XP will then prompt you to locate the driver.

Use CD-ROM and Select Automatic Installation

Ensure the CD-ROM is in the drive and select the 'Install software automatically (Recommended)' option.

Select Scanner Model and Copy Files

Select your scanner model and click Next to copy the relevant files to your hard disk.

Complete Installation Wizard

Click Finish to exit the 'Found New Hardware Wizard' after the installation process is complete.

Verifying Scanner Availability

Access System Properties

Access the 'System Properties' window by navigating through the Control Panel.

Navigate to Device Manager

Within 'System Properties', go to the 'Hardware' tab and click the 'Device Manager' button.

Verify Scanner Status in Device Manager

Double-click 'Imaging devices' to check if your scanner is listed and ready for use.